If you plan to use the non-secure version of iTP WebServer (T8996), ensure that iTP WebServer
version T8996H02 or later is installed on your system.

If you already have non-secure iTP WebServer installed on your system, check its version
by following these instructions:

Go to the

/usr/tandem/webserver/<iTP WebServer version>/bin

directory

on OSS.

where,

<iTP WebServer version>

is the version procedure of the iTP WebServer release

installed (for example,

T8996H02_09FEB09_ADE_H028_01

For example:

OSS> cd /usr/tandem/webserver/T8996H02_09FEB09_ADE_H028_01/bin

NOTE:

You may have more than one non-secure version of iTP WebServer available

on your NonStop system. Ensure that you select iTP WebServer version T8996H02 or
later.

Verify the installation by checking the version of the

httpd

object using the

VPROC

utility as follows:

OSS> vproc httpd

/usr/tandem/webserver/T8996H02_09FEB09_ADE_H028_01/bin/httpd
Binder timestamp: 25JAN2009 17:22:47
Version procedure: T8432H01_05MAY2006_CCPLMAIN
Version procedure: T8996H02_09FEB09_ADE_H028_01
TNS/E Native Mode: runnable file

The version of iTP WebServer must be T8996H02 or later.

To install and set up non-secure iTP WebServer on your NonStop system, see the iTP
Secure WebServer System Administrator's Guide.

•

If you plan to use the secure version of iTP WebServer (T8997), ensure that you have iTP
Secure WebServer version T8997H02 or later installed on your system.

If you already have iTP Secure WebServer installed on your system, check its version by
following these instructions:

Go to the

/usr/tandem/webserver/<iTP Secure WebServer version>/bin

directory on OSS.

where,

Introduction

This manual is related to the following products:

Integrity NonStop J-Series