HP Media Center m477.uk Desktop PC - Manual (Page 196)

190
hp media center pc user’s guide
Replacing the drive cage
1
Cover the front of the cage as you lift it so
that the 7-In-1 memory card reader does not
slide out.
2
Hold the drive cage at a 45-degree angle,
and place the two nubs (G) on the cage into
the two guides (H) on the chassis.
3
Align the track on the top of the drive cage (K)
with the track guide on the bottom of optical
drive bay (J). Push the drive cage firmly
toward the track guide to engage it as you
rotate the drive cage down into position. The
release tab should latch. (If you can remove
the cage by pulling up on it, the track did not
properly engage the track guide. Repeat the
steps to replace the drive cage.)
4
Push the 7-In-1 memory card reader toward
the front of the chassis until the two screw
holes align with the drive cage. (You may
have to push down the front of the reader as
you slide it out into the front panel.) Replace
the two screws that secure the 7-In-1 memory
card reader.
5
Reattach the cables to the back of the drives.
6
Replace the fan duct. See “Replacing the Fan
Duct” on page 184.
G Nub on drive cage
H Nub guides in chassis (2)
J Track guide on the bottom of the optical
drive bay
K Track on drive cage
G
H
J
K