HP StorageWorks XP Remote Web Console Software - Manual (Page 108)

Table 34 Cause of Error and the Result of RAID Manager Command (SSB) (continued)
Cause of Error RAID Manager Command SSB2 SSB1
restore
Since one of the following
cases occurred, the XP paircreate 978a
Snapshot pair cannot be
created by specifying the
consistency number.
•
The specified consistency
group number is in use
for XP Business Copy.
• The number of pairs has
already exceeded the
maximum number of
pairs that can be created
for one consistency
group.
•
The pair that uses the
same P-VOL exists
already in the specified
consistency group.
The XP Snapshot pair cannot
be created because the paircreate 978b
specified consistency group
number is out of the range
of the number that can be
specified.
The snapshot data cannot be
stored because the XP pairsplit 978c
Continuous Access
asynchronous pair status is
other than PSUS or PSUE
when XP Snapshot (P-VOL)
and XP Continuous Access
asynchronous (S-VOL) share
the volume.
The XP Snapshot pair for
which the consistency group paircreate 978e
is specified cannot be
created because the P-VOL
or S-VOL of the XP Business
Copy pair is specified as the
P-VOL of the XP Snapshot
pair.
The XP Thin Provisioning
virtual volume, which is paircreate 9790
undergoing capacity
expansion, is specified as
the XP Snapshot P-VOL.
Therefore, the XP Snapshot
pair cannot be created.
The XP Snapshot pair cannot
be created because the XP paircreate 9793
Thin Provisioning V-VOL that
is discarding zero data is
specified as a P-VOL of the
XP Snapshot pair.
108 Troubleshooting