HP StorageWorks XP Remote Web Console Software - Manual (Page 101)

Table 34 Cause of Error and the Result of RAID Manager Command (SSB) (continued)
Cause of Error RAID Manager Command SSB2 SSB1
Since you specified the
volume that is in process of paircreate,
pairsplit,
9728
formatting as the XP
pairresync,
Snapshot P-VOL, the
command ends abnormally.
pairresync -
pairresync -
Since you specified the
volume whose emulation paircreate,
pairsplit,
9729
type is other than OPEN-V
pairresync,
as the XP Snapshot P-VOL,
the command ends
abnormally.
pairresync -
pairresync -
Since the volume you
specified as the XP Snapshot paircreate 972a
P-VOL has the command
device setting, the pair
cannot be created.
Since the capacity of the
volume you specified as the paircreate 972c
XP Snapshot P-VOL exceeds
the supported size (4TB), the
pair cannot be created.
Since the capacity of the
volume you specified as the paircreate 972e
XP Snapshot S-VOL exceeds
the supported size (4TB), the
pair cannot be created.
Since you specified a V-VOL
as the XP Snapshot P-VOL,
the pair cannot be created. paircreate 972f
Since you specified a
pool-VOL as the XP Snapshot paircreate 9730
P-VOL, the pair cannot be
created.
When XP Snapshot P-VOL
and XP Continuous Access pairresync -
restore
9731
Software P-VOL share the
volume, the status of the XP
Continuous Access pair is
other than PSUS or PSUE.
Therefore, the XP Snapshot
pair cannot be restored.
When XP Snapshot P-VOL
and XP Continuous Access pairresync -
restore
9732
Journal Software P-VOL
share the volume, the status
of the XP Continuous Access
Journal pair is other than
PSUS or PSUE. Therefore,
the XP Snapshot pair cannot
be restored.
Since XP Snapshot P-VOL
and XP Continuous Access pairresync -
restore
9733
S-VOL share the volume, the
Troubleshooting When Using XP RAID Manager 101