HP StorageWorks XP Remote Web Console Software - Manual (Page 100)

Table 34 Cause of Error and the Result of RAID Manager Command (SSB) (continued)
Cause of Error RAID Manager Command SSB2 SSB1
The command ended
abnormally because the pair All commands 9719
is in the status that the
corresponding command is
not accepted at present.
This error also may be
reported when the command
is executed with specifying
an unsupported parameter.
Since the capacity of shared
memory is insufficient, the
pair cannot be created. paircreate 971a
Since the attribute of the
specified pool is other than paircreate 971b
XP Snapshot, an XP
Snapshot pair cannot be
created.
Since the volume you
specified as the P-VOL has pairresync -
restore
971f
an S-VOL Disable attribute,
an XP Snapshot pair cannot
be restored.
Any errors have occurred
because of the XP Snapshot
operation. All commands 9720
Since either XP Snapshot or
XP Business Copy Software paircreate
pairsplit
9721
is not installed, the
command ends abnormally.
pairresync
pairresync -
restore
Because of no additional
shared memory (FCV2, TPF, All commands 9723
Extention1), the command
ends abnormally.
Because of no additional
shared memory (more than All commands 9724
XP1), the command ends
abnormally.
Since the LDEV number of
the volume you specified as All commands 9725
the P-VOL is beyond the
specified range, the
command ends abnormally.
Since you specified the
unmounted volume as the XP All commands 9726
Snapshot P-VOL, the
command ends abnormally.
Since you specified the
blocked volume as the XP paircreate,
pairsplit,
9727
Snapshot P-VOL, the
command ends abnormally.
pairresync,
pairresync -
pairresync -
100 Troubleshooting