HP Designjet 350c Printer - Manual (Page 27)

1–13
Company confidential. Pelican User’s Guide, Ed 1, Final. Freeze Status: frozen
This is the cyan on page 1–13 (seq: 27)
This is the black on page 1–13 (seq: 27)
4 When all the cartridges are installed,
lower the cover.
On the front panel, the Ready light
should flash for up to about a minute
and then go off. The
Load Media light
should then be on (together with Media
Type and Print Quality lights).
Load Media
If you wish, you can now check your cartridge alignment by running the Black
Cartridge Alignment Routine (See page 5–3). However, this is normally only
required for troubleshooting.
Localization Note Treat as new.
SETUP
1
Setting up your plotter
Task 5: Load the print cartridges