HP Designjet 350c Printer - Manual (Page 141)

This is the magenta on page 9–11 (seq: 141)
9–11
Company confidential. Pelican User’s Guide, Ed 1, Final. Freeze Status: frozen
This is the cyan on page 9–11 (seq: 141)
This is the black on page 9–11 (seq: 141)
If the output is distorted or unintelligible
There is a possible explanation if the serial interface is in use:
If you are using a serial interface between the plotter and your computer, make
sure the plotter’s serial interface settings match the settings and requirements of
your software and hardware. To check or change the plotter’s settings, use the
Setup Sheet.
If the plotter has drawn a different plot than the one you were
expecting
You may have pressed Replot (giving you a copy of the last plot) or may have
accidentally initiated one of the plotter’s internal plots. For a summary of these
plots and how to print them, see page 5–2.
If pen settings seem to have no effect
You may have changed them in the Setup Sheet but forgotten to fill in the oval
called “Use settings from tables below.”
You may expect the software-driven pen settings but the Setup Sheet is set to
“Use settings from tables below”.
TROUBLE–
9
SHOOTING
Troubleshooting
Solving problems with plot position or content
Localization Note. JKCT: Very similar to Parrot UG p4-10. FIGSP: Very similar to Loquillo
750C UG p9-14.
?!
!