Task 4: switch on – HP Designjet 350c Printer User Manual
Page 23
1–9
Company confidential. Pelican User’s Guide, Ed 1, Final. Freeze Status: frozen
This is the cyan on page 1–9 (seq: 23)
This is the black on page 1–9 (seq: 23)
Task 4: Switch on
Be sure that the power cord supplied with your plotter matches your ac power
connection requirements. Use only three-wire (earth-grounded) power cords
with this plotter.
1
Make sure that the power switch on the front of the plotter is in the OFF position
(extended).
2
Plug the power cord into the socket at the back of the plotter, and then into
your power outlet.
1740a
3
Switch on the plotter, by pushing the power switch.
on
off
1741
4
If there is no sound, nor any light on the front panel, you may have a power
problem. For troubleshooting information, see chapter 9.
Localization Note JKCT: Similar to Parrot UG, p1–10.
SETUP
1
Setting up your plotter
Task 4: Switch on
W A R N I N G