Configuring the server on the network, Before you begin, Server configuration steps – HP StorageWorks 1200r All-in-One Storage System User Manual

Page 30

Using the methods described in the HP Integrated Lights–Out 2 User Guide, connect to the iLO
2 port.

NOTE:

To find the default iLO 2 log on settings, see the iLO 2 Default Network Settings card attached
to your server. The default DNS, administrator name, and password needed to log on will
be on this card.

If desired, you can change the default user name and password on the administrator account to
your predefined selections.

Set up your user accounts, if using the local accounts feature.

Activate iLO 2 advanced features by entering a license key from the included HP ProLiant Essentials
Integrated Lights-Out 2 Advanced Pack.

Access the HP All-in-One Storage System using the iLO 2 Remote Console functionality. Log on
to the HP All-in-One Storage System with the default user name administrator and the
password hpinvent. The All-in-One Management Console starts automatically.

NOTE:

When the Remote Console feature is enabled, you can get access to the storage system's
login screen.

The Integrated Lights-Out 2 port comes with factory default settings, which the administrator can
change. Administrators may want to add users, change SNMP trap destinations, or change networking
settings. See the HP Integrated Lights-Out 2 User Guide for information about changing these settings.
To obtain this guide, go to

http://www.hp.com/support/manuals

, navigate to the servers section,

and select Server management. In the ProLiant Essentials Software section, select HP Integrated
Lights-Out 2 (iLO 2) Standard Firmware.

Configuring the server on the network

Before you begin

When first powering on the storage system you need to have some configuration data readily available
to complete the

Running the Rapid Startup Wizard

. Complete the

Server configuration steps

and use

the data collected to initialize the storage system.

NOTE: