HP Storage Mirroring V5 Software - Manual (Page 32)

22 Protecting an Exchange Server
After you select the Identity Failover option, click Configure . The Configure Identity Failover window will appear.
Enter the following information for Identity failover:
• Source IP —Select the source IP address(es) to be monitored for failover.
• Target NIC —Select the target NIC to be used when failover occurs.
• Target IP Addresses —This area displays the IP address(es) of the selected target NIC.
• IP Address — (Default = selected) Select the IP Address checkbox if you want the specified source IP address to
be monitored.
NOTE: If you are in a WAN environment and choose Identity Failover , you should NOT failover the IP
address.
• Server Name — (Default = selected) Select the Server Name checkbox if you want the source name to be
added to the target when failover occurs.
• Shares — (Default = selected) Select the Shares checkbox if you want the source file shares to be added to the
target when failover occurs.
• Active Directory Hostname (SPNs) — (Default = NOT selected) This option will automatically remove the host
SPN (Service Principle Name) from Active Directory for the source and add it to Active Directory for the
target during failover.
NOTE: You should NOT select this option when using Exchange.
After the Identity failover configuration is complete, click OK to save your entries and return to the Configure
Protection window.
Services
Storage Mirroring Application Manager will determine the appropriate Exchanges services to start/stop based
on your operating system/Exchange configuration. You should only modify this selection if there are additional
services that need to be started along with Exchange during the failover/failback process (such as
BlackBerry ® ).
Modifying the default configuration for services may affect whether data can be successfully replicated. Do not
modify the services to start/stop unless you are very familiar with Storage Mirroring and Exchange.
To add a service, click
Add . In the Add Service window, select the Service name from the drop-down box, then
click Add . Alternately, you can manually enter a service, then press Enter . By default, most services must be