Rebuilding the source, Rebuilding the original exchange source, B rebuilding the source – HP Storage Mirroring V5 Software User Manual
Page 119: Brebuilding the source
HP StorageWorks Storage Mirroring Application Manager user’s guide 109
B
Rebuilding the Source
Rebuilding the original Exchange source
The following steps guide you through rebuilding a source with the same name and IP address as the original
source.
1.
Install Windows on the source, if necessary, configuring it as a Windows 200x member server with the
same name and IP address as the original source.
2.
Apply any Windows 200x service packs or patches.
3.
Connect the source to the network and join the domain.
a. On the source, right-click
My Computer
and select
Properties
.
b. Select the Network Identification tab and click
Properties
.
c. Under
Member of
, change to
Domain
and specify the domain name.
d. Click
OK
.
e. When you are prompted for a domain account, specify an account with permissions to add a
workstation to the domain.
f. Reboot when prompted.
4.
After the source reboots, log in as the domain administrator or an equivalent account. Verify that the
account has full Exchange Administrator rights.
5.
Using the Exchange CD, start the Exchange installation on the source using the following command
.
6.
At the Component Selection dialog box, set the
Action
column to
Disaster Recovery
for all of the components
that were originally installed on the source (before it failed).
7.
Verify that each of the components selected are installed in the same location on the source as they are on
the target. If not, modify the location of each component to match the target and original source
configuration.
8.
After selecting the proper components and location, click
Next
to continue the install.
9.
If you accepted the default installation on the original source (before it failed), set Microsoft Exchange
Messaging and Collaboration Services and Microsoft Exchange System Management Tools to
Disaster
Recovery
.
Target
Repaired source
connected to the network
Reverted back to original
configuration by failback
Repaired Source
Windows member server
with original source name and IP address