HP ProLiant Support Pack - Manual (Page 62)

Scripted deployment 62
Command-line
argument Description
15 and 3600.
• The default timeout value is 15 seconds for Microsoft® Windows®
operating systems and 60 seconds for Linux.
• For Linux, the Reboot Delay time is converted from seconds to minutes,
and any value under a full minute, 59 seconds or less, rounds to the next
minute.
/reboot_always • If the following conditions are met, then this argument forces the server to
reboot: The /reboot_always option is selected or given as a command-
line argument.
• All components selected for installation are successfully installed.
Creating Host Groups
/group “group_name” This argument specifies an already defined group name in the HP SUM GUI.
Simulating HP SUM
/dryrun This argument simulates the installation for a test run. Nothing is installed.
Targets
/user <username> or
/username
This argument enables you to log in to HP BladeSystem c-Class Onboard
Administrator with your user ID.
/psswd <password> This argument enables you to use the password for the user ID specified in the
/user parameter. The password is used to log in to remote hosts and HP
BladeSystem c-Class Onboard Administrators.
/current_credential (Applies to Windows® operating systems only.) This argument enables the
credentials of the local host to be used as the credentials to access the targets
instead of providing the username and password explicitly for each target.
The assumption is that the current credentials are valid for the targets being
accessed.
/target "netAddress" This argument is the IP address or the DNS name of a remote server, remote
iLO NIC port, Virtual Connect Ethernet or Fibre Channel Module for c-Class
BladeSystem, or BladeSystem Onboard Administrator.
When two Onboard Administrators are in an enclosure, this argument should
be the active Onboard Administrator. When specifying the IP address, you
can use either the IPv4 or IPv6 format.
Log Files
/logdir "path" This argument enables you to redirect the output from HP SUM or the HP
BladeSystem c-Class Onboard Administrator flash utility to a different
directory than the default location.
• For Windows® components, the default location is
%SYSTEMDRIVE%\CPQSYSTEM\hp\log and the redirected
location is \hp\log\.
• For Linux components, the default location is /var/hp/log/
and the redirected location is /hp/log/.
/v[erbose] or
/veryv[erbose]
These arguments enable you to set the verbosity level for the HP SUM
execution log file, hpsum_execution_log__.log. Using one of
these arguments increases the level of detail that is retained in the log file.
The default value is normal verbosity.
Generating Reports
/report This argument generates a report listing, a target summary, and how the