ADTRAN 1200130L2 - Manual (Page 84)

7 0 FSU User Manual 61200.130L1-1
Chapter 7. Configuring the Network Port
When connecting to an external DSU, the FSU emulates an externally
timed DTE interface connected directly to the DCE interface of the
external device. Therefore, the connection between the FSU and the
DSU is a direct connection.
1 RS232
1 INTERFACE TYPE 2 V.35
3 NETWORK
1 DTE PORT 1 2 PHYSICAL LAYER OPTIONS
1 LOOP RATE (available when
NETWORK interface type is
selected)
1 56K
2 DTE PORT 2 2 64K
2 CLOCK SOURCE (available when
NETWORK interface type is
selected)
1 MASTER
1 CONFIG 3 NETWORK PORT 2 FROM NETWORK
4 IP ROUTING
1 NETWORK BIT RATE (available
when RS232 or V.35 interface type
is selected) 56K and 64K
available for RS232
and V.35 interfaces.
5 SYSTEM CONFIG
Additional rates of
112K through 512K
available for V.35
interface.
1 SIGNALING TYPE 1 NONE
2 LMI
3 FRAME RELAY OPTIONS 2 T391 3 ANSI T1.617-D
3 N391 4 ITU-T Q.933-A
4 N392
5 N393
6 REMOTE FECN NOTIFICATION
1 DO NOT NOTIFY
2 NOTIFY REMOTE ON FECN
4 LLC2 OPTIONS 1 LLC2 ACK TIMEOUT
2 LLC2 N2 RETRY COUNTER
5 IP ADDRESS 3 LLC2 k WINDOW SIZE
4 LLC2 POLL TIMEOUT
5 LLC2 BUSY TIMEOUT
6 SUBNET MASK 6 LLC2 REJECT TIMEOUT
7 LLC2 KEEP-ALIVE TIMEOUT
7 TRANSMIT RIP REQUESTS 1 NO
8 PROCESS RECEIVED RIP PACKETS 2 YES
9 PRIORITY QUEUE RATIO (N:1)
Figure 7-1
Network Port Configuration Menu Tree
When configuring from a VT 100 terminal, the screen in Figure
7-2 will appear when Network Port is selected.
In this chapter, the VT 100 selections are listed first followed by the
Front Panel selections (if the names differ).