ADTRAN 1200130L2 - Manual (Page 54)

4 0 FSU User Manual 61200.130L1-1
Chapter 6. DTE Port Configuration
When configuring the DTE ports, select the protocol first. This
selection determines which parameters will be available in the
other three categories (Physical Layer Options, Protocol Options,
and Protocol Address Table). See Figure 6-2 for the menu tree
leading to the protocol selection. Definitions for each choice
follow, categorized by the selected protocol.
In this chapter, the VT 100 selections are listed first followed by the
Front Panel selections (if the names differ).
DISABLED
FRAME RELAY
SDLC
TRANS BOP
1 PROTOCOL BISYNC
TRANS ASYNC
1 DTE PORT 1 2 PHYSICAL LAYER OPTIONS PPP SYNC
1 CONFIG PPP ASYNC
2 DTE PORT 2 3 PROTOCOL OPTIONS SLIP
4 ADDRESS TABLE
Figure 6-2
Front Panel Protocol Menu Tree