HP XP External Storage Software - Manual (Page 78)

• Path: Number of set paths.
• FLI_TOV: Wait time (in seconds) from the switch to FLOGI when the switch is connected. External
Storage XP automatically sets this value. You cannot change the value.
• PLI_TOV: Wait time (in seconds) of PLOGI to the external array when the switch is not connected.
External Storage XP automatically sets this value. You cannot change the value.
• Margin: Additional wait time (in seconds) to FLI_TOV (FLOGI wait time) or PLI_TOV (PLOGI
wait time). External Storage XP automatically sets this value. You cannot change the value. As
a result, the sum of the FLI_TOV time and margin time, or the sum of the PLI_TOV time and
margin time is set as a total wait time.
• Status: Status of the path set in the port identified by the WWN. The highest emergency level
status is displayed when two or more paths are set. One of the following statuses is displayed:
• Normal: Path is normal.
• Unknown: Path status is unknown.
• Blockade: Path is blocked.
• Disconnect: Connection to the external array or external LU was intentionally stopped using
the Disconnect Subsystem or Disconnect Volume command.
• Warning: There are paths whose status is not normal. Check the status of the paths.
• Checking: Process of checking the defined configuration information of the paths is in
progress.
• Port number of the local array
• Port: Port number of the local array selected in the Port tree. One of the following icons appears
for each port:
Description Icon
Port in Standard mode.
Port in Initiator/External MIX mode.
• WWN: WWN identifying the external array's port. This port is connected to the local array
port selected in the Port tree.
• LUN: External array's LU number.
• Characteristic: External LU's identification number.
• Group: External LU group number and reference number assigned to each LU in the external
LU group. External Storage XP automatically assigns the reference numbers to LUs in the group
when the external LUs are mapped. This is displayed in the format of “external LU group number
- reference number of volume in the group”.
• Status: Status of the path configured by the port of the local array and the port of the external
array identified by the WWN.
• Normal: Path is normal.
• Unknown: Path status is unknown.
• Blockade: Path is blocked.
• External device setting changed: External array's setting changed. For example, the path
definition was deleted or the external array itself was replaced by another device.
• LDEV size reduced: External array's volume capacity changed (volume capacity was
reduced).
• Not ready: External array replied NOTREADY.
External Storage XP panes 78