HP XP External Storage Software User Manual
Page 165
Parameter setting
Parameter
Pane name
You can either specify this
parameter or omit
specifying this parameter.
ROM Microprogram
Version
You can either specify this
parameter or omit
specifying this parameter.
RAM Microprogram
Version
You can either specify this
parameter or omit
specifying this parameter.
WEB Title
Reset/LIP Mode
Port Type
You can either specify this
parameter or omit
specifying this parameter.
•
Reset/LIP Mode
(Signal)
You can either specify this
parameter or omit
specifying this parameter.
•
Reset/LIP Mode
(Process)
You can either specify this
parameter or omit
specifying this parameter.
•
LIP Reset Mode
You can either specify this
parameter or omit
specifying this parameter.
RS232C Error Information
Outflow Mode
Controller Option
Set this parameter to ON.
Write and verify mode
Set this parameter to
Standard Mode.
Host Connection Mode 1
Host Connection Mode
Specify HISUP Mode.
NOTE:
Do not specify any other
parameters.
Host Connection Mode 2
NOTE:
When using the Thunder 9500V subsystem as an external array, the following versions are recommended.
If you use a 9500V subsystem whose version is earlier than the following versions, the SATA drive's
information might not be displayed correctly.
•
For Thunder 9530V, Thunder 9520V, Thunder 9570V: version 0658 or later
•
For Thunder 9580V, Thunder 9585V: version 1658 or later
External Storage XP user guide for the XP12000, XP10000, SVS200
165