HP XP External Storage Software - Manual (Page 169)

Connecting TagmaStore AMS and TagmaStore WMS
subsystems
System parameters for connecting TagmaStore AMS and TagmaStore WMS
subsystems
Table 17 explains whether to specify system parameters when making settings for ports on TagmaStore
AMS and TagmaStore WMS subsystems.
NOTE:
When connecting to a TagmaStore AMS or TagmaStore WMS subsystem, use LUN Manager to set the
data transfer speed of the XP12000/XP10000/SVS200 external port you use to a fixed value other than
Auto Negotiation. Also, set the data transfer speed of the target port of the TagmaStore AMS or TagmaStore
WMS subsystem to the same fixed value according to the data transfer speed of the external port.
Table 17 System parameter settings (TagmaStore AMS and TagmaStore WMS subsystems)
Parameter setting Parameters Pane
name
Start Attribute Boot
Options
Specify this parameter when the TagmaStore AMS or
TagmaStore WMS subsystem is in the one-controller
configuration. • Single Mode
Specify this parameter when the TagmaStore AMS or
TagmaStore WMS subsystem is in the two-controller
configuration. • Dual Active Mode
You can either specify this parameter or omit specifying this
parameter. Delay Planned Shutdown
You can either specify this parameter or omit specifying this
parameter. Drive blocking mode
Keep this parameter as HITACHI (default), and do not change. Vendor ID
Keep this parameter as DF600F (default), and do not change. Product ID
You can either specify this parameter or omit specifying this
parameter. ROM Microprogram Version
You can either specify this parameter or omit specifying this
parameter. RAM Microprogram Version
You can either specify this parameter or omit specifying this
parameter. Option System
Parameter
Set this parameter to Reset of occurred. Operation if the processor
failure occurs
External Storage XP user guide for the XP12000, XP10000, SVS200 169