Connecting thunder 9500v subsystems – HP XP External Storage Software User Manual
Page 164
Connecting Thunder 9500V subsystems
System parameters for connecting Thunder 9500V subsystems
explains whether to specify system parameters when making settings for ports on the Thunder
9500V subsystem.
Table 13 System parameter settings (Thunder 9500V subsystems)
Parameter setting
Parameter
Pane name
Start Attribute
System Startup Settings
Specify this parameter
when the Thunder 9500V
•
Single Mode
subsystem is in the
one-controller
configuration.
Specify this parameter
when the Thunder 9500V
•
Dual Active Mode
subsystem is in the
two-controller
configuration.
NOTE:
Be sure to specify that
Data Share Mode will
be used.
Do not specify this
parameter.
•
Hot Stand-By Mode
You can either specify this
parameter or omit
specifying this parameter.
Delay Planned Shutdown
Common 1
You can either specify this
parameter or omit
specifying this parameter.
SCSI Fibre Channel
Common Options
OPTION 1
You can either specify this
parameter or omit
specifying this parameter.
SCSI Fibre Channel
Common Options
OPTION 2
Set this parameter to
Reset of occurred.
Operation if the processor
failure occurs
Data Striping
Set this parameter to ON.
Command Queuing
Mode
Inquiry Setting
Keep this parameter as
HITACHI (default), and do
not change.
Vendor ID
Keep this parameter as
DF600F (default), and do
not change.
Product ID
Notes on connecting external arrays
164