AltiGen comm ACM 5.1 - Manual (Page 171)

Chapter 12: Trunk Configuration
AltiWare ACM 5.1 Administration Manual 157
Triton T1/E1 Trunk Properties
To open a configuration dialog box for a Triton T1/E1 channel, do one of the following:
•
If you’re in the Trunk Configuration window, select a Triton T1/E1 channel from
the trunk channels list, then click the Trunk Properties button, or just double-click
the channel in the list.
•
If you’re in the Trunk View window, right-click the channel and select Channel
Properties.
Figure 6. Triton T1 Configuration dialog box
Following are the parameters for the Triton T1 Configuration dialog box:
Parameter Description
T1 robbed-bit signaling
Protocol You can set Protocol to one of the following:
•
E&M Wink Start (default)
• E&M Immediate Start
•
Ground Start
•
Loop Start
For signaling from one board to another, only E&M Wink
Start is supported. Loop Start, Ground Start, and E&M
Immediate Start protocols cannot be used for interfacing
between two boards.
Dialing Delay Specifies the delay, in milliseconds, after trunk seizure and
before digit dialing. This configuration will slow down the
system transmitting digits to the CO by a defined delay to
avoid missing digits. Do not change this value unless advised.
Caller ID and DID Collection