beautypg.com

Layer 3 configuration file – Avaya Stackable Switch P3343T-ML User Manual

Page 84

background image

Chapter 10 Switch Configuration

68

Avaya P334T-ML User’s Guide

Layer 3 Configuration File

The Configuration File feature allows the user to read the routing configuration
parameters and save them to a file on the station. The routing configuration
commands in the file are in CLI format. The user can edit the file (if required) and
re-configure the router module by uploading the configuration file.
Although the file can be edited, it is recommended to keep changes to the file to a
minimum. The recommended configuration method is using MSNM P330 Device
Manager and/or the CLI. Changes to the configuration file should be limited to
those required to customize a configuration file from one router to suit another.
To upload or download Layer 3 configuration files, you must be in a router mode.
Use the CLI commands briefly described below for uploading and downloading
Layer 3 configuration files. The rules of syntax and output examples are all set out
in detail in the Reference Guide.

Upload a module configuration file
from the device using TFTP

copy module-config tftp

Upload a stack configuration file
from the device using TFTP

copy stack-config tftp

Upload the running configuration
file from the device using TFTP
(only applicable when the device
mode is Layer 2)

copy running-config tftp

Display the status of file uploads

show upload status

Display the status of file downloads

show download status

In order to...

Use the following command...

Download a startup configuration
file to the device using SCP

copy scp startup-config
Note:

To use the startup

configuration file, run the
copy running-config
starting-config command
after the configuration file is
downloaded to the device.

In order to...

Use the following command...