Avaya Stackable Switch P3343T-ML - Manual (Page 151)

Chapter 12 Avaya P330 Layer 3 Features
Avaya P334T-ML User’s Guide 135
OSPF CLI Commands
In order to... Use the following command...
Enable OSPF protocol router ospf
Configure the area ID of the router area
Configure router identity ip ospf router-id
Configure a passive ospf interface passive-interface
Redistribute routing information
from other protocols into OSPF redistribute
Configure the delay between runs
of OSPF’s SPF calculation timers spf
Configure interface metric ip ospf cost
Specify the time interval between
hellos the router sends ip ospf hello-interval
Configure the interval before
declaring the neighbor as dead. ip ospf dead-interval
Configure interface priority used in
DR election ip ospf priority
Configure the interface
authentication password ip ospf authentication-key
Display general information about
OSPF routing show ip ospf
Display the OSPF-related interface
information show ip ospf interface
Display OSPF neighbor
information on a per-interface basis show ip ospf neighbor
Display lists of information related
to the OSPF database for a specific
router show ip ospf database
Configure an interface as passive passive-interface