Avaya Stackable Switch P3343T-ML - Manual (Page 165)

Chapter 12 Avaya P330 Layer 3 Features
Avaya P334T-ML User’s Guide 149
• The main difference between the VRRP and SRRP is the capability of the first
protocol to provide mutual redundancy among any number of routers
supporting the protocol while the SRRP is one direction protocol
SRRP CLI Commands
In order to... Use the following command...
Configure SRRP options, activate
SRRP and enter the SRRP
configuration mode router srrp
Disable SRRP no router srrp
Backup an additional interface of
the main router using the SRRP
application ip srrp backup
Configure the polling interval in
seconds used by SRRP poll-interval
Set the polling interval used by
SRRP back to default no poll-interval
Configure the timeout after which
SRRP declares the main router dead
if it does not reply to polling timeout
Set back to default the timeout after
which SRRP declares the main
router dead if it does not reply to
polling no timeout
Display the SRRP configuration
and status show ip srrp