Avaya Stackable Switch P3343T-ML - Manual (Page 148)

Chapter 12 Avaya P330 Layer 3 Features
132 Avaya P334T-ML User’s Guide
RIP2
RIP2 overcomes some of the shortcomings of RIP. The table below summarizes the
differences between RIP and RIP2.
RIP CLI Commands
Table 12.1 DIfferences Between RIP and RIP2
RIP2 RIP
Multicast addressing Broadcast Addressing
Event-driven Timer-based (update every 30
seconds)
VLSM support (subnet information
transmitted) Fixed subnet masks
In order to... Use the following command...
Configure the Routing Information
Protocol (RIP) router rip
Specify a list of networks on which
the RIP is running network
Redistribute routing information
from other protocols into RIP redistribute
Specify the RIP version running on
the interface basis ip rip rip-version
Set the interface RIP route metric
value default-metric
Set the RIP Send and Receive mode
on an interface ip rip send-receive
Enable learning of the default route
received by the RIP ip rip default-route-mode
Enable split-horizon with poison-
reverse on an interface ip rip poison-reverse
Enable split-horizon mechanism ip rip split-horizon