Avaya Stackable Switch P3343T-ML - Manual (Page 119)

Chapter 11 Avaya P330 Layer 2 Features
Avaya P334T-ML User’s Guide 103
Intermodule Port Redundancy
The intermodule port redundancy feature supports one pair of redundant ports per
stack. The secondary port is activated:
•
when the primary port link is down, or
• when the module in the stack holding the primary port has been powered down
or removed.
Switching time for intermodule port redundancy is approximately 1 second.
L Defining intermodule port redundancy on ports with no link causes both ports
to be disabled. You should connect the link prior to attempting to define
intermodule port redundancy.
L Once a port has been designated in a redundancy scheme, either as a primary or
a secondary port, it can not be designated in any other redundancy scheme.
L Intermodule Port Redundancy does not interworks with the Spanning Tree
Algorithm.
Port Redundancy CLI Commands
The following table contains a list of the CLI commands for the Redundancy feature.
The rules of syntax and output examples are all set out in detail in the P330 Reference
Guide.
In order to... Use the following command...
Define or remove port redundancy
schemes set port redundancy
Enable the defined port
redundancy schemes set port redundancy enable
Disable the defined port
redundancy schemes set port redundancy disable
Define the timers that control the
port redundancy operation set port redundancy-interval
Display information on port
redundancy schemes. show port redundancy
Define the switch’s unique
intermodule redundancy scheme set intermodule port redundancy
Clear the intermodule redundancy set intermodule port redundancy
off