beautypg.com

Mac aging, Overview, Configuring the p330 for mac aging – Avaya Stackable Switch P3343T-ML User Manual

Page 115: Mac aging cli commands

background image

Chapter 11 Avaya P330 Layer 2 Features

Avaya P334T-ML User’s Guide

99

MAC Aging

Overview

The MAC Aging feature allows the user to configure a time interval after which
unused entries in the MAC Table will be deleted.

Configuring the P330 for MAC Aging

This section describes the configuration of the P330 for the MAC Aging
functionality.

MAC Aging is configured on the stack level.

MAC Aging can be globally enabled/disabled using the set mac-aging
command.
— After firmware upgrade to version 4.0, MAC Aging default state is disabled.
— After NVRAM INIT, MAC Aging default state is enabled.

“mac-aging-time” is set in minutes:
— Default=5 minutes
— Minimum time=1 minute; maximum time= 3600 min

L On a mixed P330/P330-ML stack, MAC Aging—if enabled—will apply only to

P330-ML modules in the stack.

MAC Aging CLI Commands

The following table contains a list of the CLI commands for the MAC Aging feature.
The rules of syntax and output examples are all set out in detail in the P330 Reference
Guide
.

In order to...

Use the following command...

Enable/Disable MAC Aging

set mac-aging

Set the MAC aging time in minutes
(0=don’t age).

set mac-aging-time

Display the current status of the
MAC aging function

show mac-aging

Display the MAC aging time in
minutes.

show mac-aging-time