Avaya P333T - Manual (Page 93)

Chapter 6 CLI – Layer 2
Avaya P333T User’s Guide 77
show secure mac port
Use the show secure mac port command to display the secure MAC addresses
of a port from the sub-agent CLI. This command is accessed only through
connection to a particular switch.
Note: This command is not supported by the P330-ML switches.
Note: If this command is to be implemented on a switch other than the stack master,
a session should be opened to the relevant switch.
The syntax for this command is:
show secure mac port [[/port]]
Output Example:
P330-N> show secure mac port 1
Port Secure-Src-Addrs
------ -----------------
1/17 00-50-04-07-6a-fa
01-02-03-04-05-06
show arp-tx-interval
Use the show arp-tx-interval command to display the keep-alive frames
transmission interval.
The syntax for this command is:
show arp-tx-interval
Output Example:
P330-N> show arp-tx-interval
ARP tx interval is set to 5 seconds.
show arp-aging-interval
Use the show arp-aging-interval command to display the ARP table aging
interval for gateways’ entries.