Avaya P333T - Manual (Page 66)

Chapter 6 CLI – Layer 2
50 Avaya P333T User’s Guide
show port
Use the show port command to display port status.
The syntax for this command is:
show port [[/]]
Output Example:
To display the status for port 4 on switch 3:
P330-N> show port 3/4
Port Name Status Vlan Level Neg Dup. Spd. Type
------ ------- --------- ---- ------ ------- ---- ---- -------------
3/4 John connected 1 4 enable half 10M 100/1000Base-Tx
Show Port Output Fields
mod_num (Optional) Number of the switch. If you do not specify a
number, the ports on all switches are shown.
port_num (Optional) Number of the port on the switch. If you do not
specify a number, all the ports on the switch are shown.
You can also specify a range of ports separated by a dash, e.g.,
5-13 for ports 5 to 13.
Field Description
Port Switch and port number
Name The name you assigned to the port
Status Status of the port (connected, no link, disabled, no Rmt Lnk)
VLAN VLAN ID of the port
Level Priority level of the port (0-7)
Neg The autonegotiation status of the port (enable, disable)
Duplex Duplex setting for the port (fdx, hdx)
Speed Speed setting for the port (10, 100)