Avaya P333T - Manual (Page 113)

Chapter 6 CLI – Layer 2
Avaya P333T User’s Guide 97
set device-mode
Use the set device-mode command to change the Basic Mode of Operation of
the P332-ML/P332GT-ML/P333R/P333R-LB switches between Router and Layer 2
modes.
Note: This command is not supported by the P333T/P334T/P332MF switches
which do not have Router mode.
The syntax for this command is:
set device-mode
set interface
Use the set interface command to configure the management interface on the
Master agent of the stack.
The syntax for this command is:
set interface inband
Output Example:
P330-N# set interface inband 1 192.168.42.252 255.255.255.0
Interface inband IP address set.
You must reset the device in order for the change to take effect.
mode Router | Layer2
inband Interface name used for the management
vlan The number of the VLAN to be used for management
ip_addr IP address used for managing the stack
netmask Subnet mask of the management interface