Set commands summary table, Ge 88 – Avaya P333T User Manual
Page 104
Chapter 6
CLI – Layer 2
88
Avaya P333T User’s Guide
Set Commands Summary Table
Following is a Table of the Privileged Level
set
commands.
• set logout
Sets the number of minutes before an
inactive CLI session automatically logs
out.
Page 91
• set timezone
Sets the timezone for the system.
Page 92
• set time protocol
Sets the time protocol for use in the
system.
Page 92
• set time server
Sets the NTP server address.
• set time client
Enables or disables the time client.
• set ip route
Adds IP addresses to the IP routing
table.
Page 93
• set snmp community
Sets the SNMP community string for a
specific switch.
Page 94
• set snmp trap
Sets the SNMP trap of the system or
add/delete an entry into/from the
SNMP trap receiver table.
Page 94
• set snmp trap auth
Enables/disables the SNMP
authentication trap.
Page 95
• set snmp retries
Sets the number of SNMP retries.
• set snmp timeout
Sets the SNMP timeout.
• set system location
Sets the system location.
• set system name
Sets the system name.
• set system contact
Sets the system contact person.
• set device-mode
Sets the basic mode of operation.
• set interface
Configures the management interface of
the device.
Page 97
• set interface ppp
Configures the device ppp interface.
Page
• set port level
Sets the priority level of a port.
• set port negotiation
Sets the auto negotiation mode of a port.
• set port enable
Administratively enables a port.