Show autopartition, Show dev log file, Show log – Avaya P333T User Manual
Page 83: Show autopartition show dev log file show log, Ge 67, E 67
Chapter 6
CLI – Layer 2
Avaya P333T User’s Guide
67
show autopartition
Use the
show autopartition
command to display the automatic partition.
Note:
Autopartition for the P330-ML switches will always have the value
disabled
. This command is used to display the autopartition status for the other
P330 switches in the stack.
The syntax for this command is:
show autopartition [module]
Example:
P330-N> show autopartition 1
Mod Mode
--- -----------
1 Enable
show dev log file
Use the
show dev log file
command to display the encrypted device’s log file.
Note:
This command is only supported by the P330-ML switches.
The syntax for this command is:
show dev log file
show log
Use the
show log
command to display an encrypted device’s reset log. This
command is for Avaya technical support use.
The syntax for this command is:
show log [module]
Output Example:
P330-1(super)# show log 1
MODULE 1, MESSAGE 01:
00000000 0 05002966 0205 0 0 0 0 0 0 0 0 0 0
MODULE 1, MESSAGE 02: