Show interface, Show device-mode, Show interface show device-mode – Avaya P333T User Manual
Page 65: E 49, Ge 49
Chapter 6
CLI – Layer 2
Avaya P333T User’s Guide
49
The syntax for this command is:
show logout
Output Example:
P330-N> show logout
CLI timeout is 10 minutes
show interface
Use the
show interface
command to display information on network
interfaces.
The syntax for this command is:
show interface
Output Example:
To display the interface:
P330-N> show interface
Interface Name VLAN IP address Netmask
-------------- ---- --------------- ---------------
inband 1 10.0.0.1 255.255.255.0
ppp disable 1 0.0.0.0 0.0.0.0
show device-mode
Use the
show device-mode
command to show the P332G-ML/P332GT-ML/
P333R/P333R-LB operating mode you are currently in. Possible modes are Router,
or Switch.
Note:
This command is not supported by the P333T/P334T/P332MF/P333T-PWR
switches which do not have Router mode.
The syntax for this command is:
show device-mode