Avaya P333T - Manual (Page 130)

Chapter 6 CLI – Layer 2
114 Avaya P333T User’s Guide
set port auto-negotiation-flowcontrol-advertisement
The set port auto-negotiation-flowcontrol-advertisement command
sets the flowcontrol advertisement for a Gigabit port when performing
autonegotiation.
The syntax for this command is:
set port auto-negotiation-flowcontrol-advertisement /
{no-flowcontrol|asym-tx-only|sym-only|sym-and-asym-rx}
Output Example:
P330-N# set port auto-negotiation-flowcontrol-advertisement
1/5 asym-tx-only
P330-N# Port 1/5 pause capabilities was set
set trunk
Use the set trunk command to configure the tagging mode of a post.
set trunk [module/port] [value]
Output Example:
P330-1(super)# set trunk 2/20 dot1q
Dot1Q VLAN tagging set on port 2/20.
no-flowcontrol The port will advertise no pause capabilities.
asym-tx-only The port will advertise asymmetric Tx pause capabilities only.
sym-only The port will advertise symmetric pause capabilities only.
sym-and-asym-rx The port will advertise both symmetric and asymmetric Rx
pause capabilities.
module/port module/port number
value off/dot1q