Table 3.2, Avaya p330 <- -> select buttons – Avaya P333T User Manual
Page 26

Chapter 3
Avaya P333T Front and Back Panels
10
Avaya P333T User’s Guide
Note:
To perform “Force Initial Version” reset the module and at the same time
press the FIV reset button (use an opened paper clip or other pointed object).
Release the reset buttons first and 1 or 2 seconds later, release the FIV button.
Note:
The Port LEDs of the P333T are numbered from 1-24. Expansion Module ports
are numbered from 51. Port LED numbers 49-50 are reserved.
FC
Flow Control
OFF – No Flow Control
ON – Symmetric/Asymmetric Flow Control
mode is enabled and port is in full duplex
mode.
Hspd
High Speed
10/100
1000
OFF:
10
N/A
ON:
100
1000
LAG
Link Aggregation
Group (Trunking)
OFF – No LAG defined for this port
ON – Port belongs to a LAG
Table 3.2
Avaya P330 <- -> Select buttons
Description
Function
Left/Right
Individual – select LED function (see table above).
Reset module
Press both right and left buttons together for approximately two
seconds. All LEDs on module light up until buttons are
released.
Reset stack
Press both right and left buttons together for 4 seconds. All
LEDs on stack light up until buttons are released.
FIV
Force Initial Version – boot from backup initial version of the
Avaya P330 software, from Bank A (see Note below).
Table 3.1
Avaya P333T LED Descriptions
LED Name
Description
LED Status