Avaya P333T - Manual (Page 49)

Chapter 5 Avaya CLI – Architecture, Access & Conventions
Avaya P333T User’s Guide 33
Command Line Prompt
When you start the CLI, the initial prompt shows the number of the Master module
in the Avaya P330 stack. For example, if the stack Master is Module 5, counting from
the bottom up, then the prompt is:
P330-5>
In this document the Module number in the prompt is generic and is represented by
“
N ”.
If you wish to open a session with an Avaya P333R-LB routing module in the stack
or reopen a session with the Master module, use the
session command (see
below).
The command prompt is not hierarchical in structure. If you wish to use several
commands, each beginning with the same keyword, you must retype all parts of
the command each time. For example, if after you want to set the system contact
and the system name you must type both
set system contact and set
system name . However, you can use command abbreviations.
Avaya P330 Sessions
You can use sessions to switch between P330 modules or to switch between Layer 2
and Layer 3 commands in the P333R CLI.
To switch between P330 modules use the command:
session [] .
The < mod_num > is the number of the module in the stack, counting from the bottom
up. The < mode > can be either switch or router. When Module Number is not
specified, the command switches between the modes in the local module. Use
switch
mode to configure layer 2 commands. Use router mode to configure routing
commands.
Examples:
To configure router parameters in the module that you are currently logged into,
type the following command:
session router .
To configure the switch parameters, on module 6, type the command:
session 6 switch .
Note: When you use the session command the security level stays the same.