Avaya P333T - Manual (Page 105)

Chapter 6 CLI – Layer 2
Avaya P333T User’s Guide 89
• set port disable Administratively disables a port. Page 100
• set port speed Sets the speed for a 10/100 port. Page 101
• set port duplex Sets the duplex mode of a port. Page 101
• set port name Assigns a name to a port. Page 102
• set port trap Enables/disables the SNMP up/down
link traps sent for port. Page 102
• set port vlan Assigns the Port VLAN ID (PVID). Page 102
• set port vlan-binding-
mode
Defines the port binding method. Page 103
• set port static-vlan Defines a multiple VLANs per port. Page 103
• set port self-loop
discovery
Admin_Status
Defines a port’s IBM token ring
discovery mode. Page 104
• set port channel Defines a LAG interface. Page 104
• set port classification Defines port classification. Page 105
• set port redundancy
on/off
Defines/deletes a link redundancy
entry. Page 106
• set port redundancy Enables/disables all the defined link
redundancy schemes. Page 106
• set internal buffering Sets internal buffering capacity to
maximum/minimum. Page 107
• set boot bank Configures the boot bank from which
the switch will boot. Page 107
• set intermodule port
redundancy
Defines the stack’s unique fast
redundancy scheme. Page 108
• set intermodule port
redundancy off
Clears the intermodule redundancy. Page 108
• set port mirror Sets a port mirroring source-destination
pair in the stack. Page 109
• set port spantree Enables or disables the spanning tree for
switch ports. Page 109
• set port spantree
priority
Sets the port spantree priority level. Page 110