Canon VB-M700F - Manual (Page 63)

5
-19
5
S
etting Page
Image Buffer
1 [Frame Rate]
Set the frame rate that applies when images are
temporarily saved in the image buffer at the moment an
event occurs.
2 [Pre-event Buffer (number of image frames)]
Set the number of images to be buffered before the
event.
3 [Post-event Buffer (number of image frames)]
Set the number of images to be buffered after the
event.
Volume Detection
1 [Volume Detection Event]
Set volume detection to [Enable] or [Disable].
2 [Detection Criteria]
Set the criteria for generating volume detection events
to [The reference volume level or above] or [The
reference volume level or below].
3 [Reference Volume Level]
Set the reference volume level for detection in the
range of 0 to 100.
Perform an actual test at the volume level before setting
the value.
4 [Detect Criteria Duration (sec)]
Set the duration of the detect criteria in the range of 0
to 10 (sec.). When the status meeting the detect criteria
has continued for the duration or longer, an ON event is
generated.
5 [ON Event Operation]
Select the operation to be performed upon an ON
event. If [Enable] is selected, 7 [Upload] and 8 [E-
mail Notification] will be executed according to their
settings upon an ON event.
6 [OFF Event Operation]
Select the operation to be performed upon an OFF
event. If [Enable] is selected, 7 [Upload] and 8 [E-
mail Notification] will be executed according to their
settings upon an OFF event.
7 [Upload]
Select the upload operation to be performed. If [Enable]
is selected, upload is performed when a volume
detection event occurs. To use this function, the
[General Upload] sub-menu and [HTTP Upload] or [FTP
Upload] sub-menu must also be set from the [Upload]
menu (P. 5-14).
[Event]
Setting Image Buffer, Volume Detection, Audio Playback and Timer
The following can be set here.
• Image Buffer
Set the items associated with the temporary
saving of images in the image buffer.
• Volume Detection
Set the operation to be performed at the time of
volume detection.
• External Device Input
Set the operation to be performed when an event
is triggered by input from an external device.
• Timer
Set timer events.
• Sound Clip Upload
Set the audio file registered as playback.
Important
• The maximum image buffer size capacity is approx. 6 MB.
If a large image size is set, the Frame Rate, Pre-event Buffer
and Post-event Buffer may not be achieved as specified
(P. 5-19).
• If buffering cannot be achieved as specified, an event log
message appears (P. 5-32).
Before using a large image size, confirm that no messages
appear in the event log (P. 5-32).