Canon VB-M700F - Manual (Page 53)

5
-9
5
S
etting Page
Camera Name
[Camera Name]
Be sure to enter [Camera Name (alphanumeric
characters)].
Up to 15 ASCII characters (spaces and printable
characters) may be used for [Camera Name
(alphanumeric characters)].
Note
• The camera name set here will be shown when the camera is
registered for use with bundled RM-Lite.
Initial Camera Settings
1 [AE Mode], [Slow Shutter], [Shutter Speed]
Set the exposure control and shutter speed for the
camera startup.
[AE Mode]
[Auto]
The exposure is controlled automatically.
[Auto (Flickerless)]
In this mode, image flickers caused by fluorescent
lights, etc., can be reduced. The shutter speed is
automatically adjusted according to the brightness
of the environment in which the camera is used.
[Auto (Shutter-priority AE)]
In this mode, a desired shutter speed can be
specified.
[Slow Shutter]
Slow shutter can be used only if [Auto] is selected in
[AE Mode].
Set the maximum slow shutter time to be used when
in auto exposure mode when capturing video in a
dark place. Select [Disable], [1/15] or [1/8]. As
longer shutter times generate residual images when
capturing a moving subject, select an appropriate
time according to the capture conditions.
[Shutter Speed]
Shutter speed can be used only if [Auto (Shutter-priority
AE)] is selected in [AE Mode].
Select a desired shutter speed from the 12 levels from [1/
8] to [1/8000]. When capturing a moving subject,
selecting a higher shutter speed can reduce blurry image
capture.
2 [Exposure Compensation]
The exposure compensation when the camera starts
can be set in the range of -3 to 3. To brighten the
image, set a positive value. To darken the image, set a
negative value.
3 [Metering Mode]
Set the metering mode when the camera starts.
[Center-Weighted]
The entire screen is metered by focusing on the
center of the screen.
Even when slightly darker/brighter areas are present
on the periphery of the screen, an appropriate
exposure can be achieved for the subject near the
center.
Use this mode if the subject is positioned near the
center of the screen.
[Average]
The entire screen is metered by averaging.
A stable exposure can be achieved even in a
capture environment where there are notable
brightness differences within the screen.
Use this mode to stabilize the exposure in locations
where vehicles or people are moving.
[Camera] Setting Initial Camera Settings and External Device Name
The following can be set here.
• Camera Name
Enter the name of the camera. The camera name
is required for use with RM-Lite.
• Initial Camera Settings
Set the AE mode and shutter speed, exposure
compensation, metering mode, smart shade
control and white balance for the camera startup.
• Day/Night
Set the day/night switching mode.
• Installation Conditions
Set LED to On/Off.
• External Device Name
Set the external input device name and external
output device name.
VB-M700F