NORD Drivesystems BU2200 - Manual (Page 23)

POWERLINK Bus module –
Supplementary manual options for NORD - Frequency Inverters
BU 2200 GB-3813 23
Interruption of parameter communication (SDO)
If problems occur during parameter communication (e.g. value range overflow), a cancel telegram is
sent. The error codes comply with the POWERLINK standard EPSG DS 301.
Pos : 41 /Anl eitungen/ Elektroni k/ Bus s yst eme/4. Kommuni kati on und Prot okoll + Proz ess datentr ans fer /POWER LIN K [ BU 02200]/F ehl ercodes f ür den g esc heit ert en Paramet erzugriff [SK xU x-PO L] @ 4\ mod_1378807315893_388. doc x @ 93921 @ @ 1
Error code Explanation
0x0504 0000 Timeout of the SDO response by the bus module
0x0504 0001 Unknown SDO command
0x0504 0002 The size of the transferred data is not correct
0x0504 0003 Error in sequence layer
0x0504 0005 Insufficient memory
0x0601 0000 Access to the object is not supported
0x0601 0001 Reading access to write-only parameter
0x0601 0002 Writing access to a read-only parameter
0x0602 0000 Access to a non-existent parameter
0x0604 0043 Incompatible parameter
0x0604 0047 Internal incompatibility in module
0x0606 0000 Hardware error
0x0607 0010 The data type does not match the length of access
0x0607 0012 Parameter access with excess data length
0x0607 0013 Parameter access with insufficient data length
0x0609 0011 Parameter sub-index does not exist
0x0609 0030 Parameter value range overflow
0x0609 0031 Parameter value too large
0x0609 0032 Parameter value too small
0x0609 0036 Maximum value smaller than the minimum value
0x0800 0000 General error
0x0800 0020 Reading / writing of parameter not possible as there is no connection between the FI and the
module
0x0800 0021 Module does not react
Table 16: Error codes for parameter access failure
Pos : 42 /Anl eitungen/ Elektroni k/ Bus s yst eme/5. Par ameter/! Kapi tel Paramet er [ Allgemei n] @ 3\ mod_1369131249731_388. doc x @ 69921 @ 1 @ 1