West Control Solutions N8840 - Manual (Page 46)

g
Resetting the controller configuration to factory setting (Default)
r chapter 12.1 (page 85)
+ 8800/8840 Configurator - the engineering tool for the West controller series
3 engineering tools with different functionality facilitating 8840 profiler
configuration and parameter setting are available (see chapter 10: Accessory
equipment with ordering information).
In addition to configuration and parameter setting, the engineering tools are
used for data acquisition and offer long-term storage and print functions. The
engineering tools are connected to the 8840 profiler via the front-panel
interface by means of PC (Windows 95 / 98 / NT) and a PC adaptor.
Description 8800/8840 Configurator:
see chapter 9: 8800/8840 Configurator (page 77).
Configuration level
Configuration parameters 46 8840 profiler
Lin
(only visible with 8800/8840 Configurator
Name Value range Description Default
Lin Linearization for inputs INP1 or INP3
Access to this table is always with selection special
thermocouple for InP.1 or InP.3or with setting
S.Lin = 1: special linearization for linearization.
Default: KTY 11-6 (0...4,5 kOhm)
In.1 -999.0..99999 Input value 1
The signal is in [µV] or in [[] dependent of input type
1036
Ou.1 0,001...9999 Output value 1
Signal assigned to In.1
-49,94
In.2 -999.0..99999 Input value 2
The signal is in [µV] or in [[] dependent of input type
1150
Ou.2 0,001...9999 Output value 2
Signal assigned to In.2
-38,94
:
:
:
:
:
:
:
:
In.16
-999.0..99999 Input value 16
The signal is in [µV] or in [[] dependent of input type
4470
Ou.16
0,001...9999 Output value 1 6
Signal assigned to In.16
150,0