West Control Solutions N8840 - Manual (Page 34)

1 with current and voltage input signals, scaling is required (see chapter 5.3)
Configuration level
Configuration parameters 34 8840 profiler
Name Value range Description Default
S.tYP Sensor type selection 30
0 thermocouple type L (-100...900°C) , Fe-CuNi DIN
1 thermocouple type J (-100...1200°C) , Fe-CuNi
2 thermocouple type K (-100...1350°C), NiCr-Ni
3 thermocouple type N (-100...1300°C), Nicrosil-Nisil
4 thermocouple type S (0...1760°C), PtRh-Pt10%
5 thermocouple type R (0...1760°C), PtRh-Pt13%
6 thermocouple type T (-200...400°C), Cu-CuNi
7 thermocouple type C (0...2315°C), W5%Re-W26%Re
8 thermocouple type D (0...2315°C), W3%Re-W25%Re
9 thermocouple type E (-100...1000°C), NiCr-CuNi
10 thermocouple type B (0/100...1820°C), PtRh-Pt6%
18 special thermocouple
20 Pt100 (-200.0 ... 100,0 °C)
21 Pt100 (-200.0 ... 850,0 °C)
22 Pt1000 (-200.0 ... 850.0 °C)
23 special 0...4500 Ohm (preset to KTY11-6)
24 special 0...450 Ohm
30 0...20mA / 4...20mA 1
41 special -2,5...115 mV 1
42 special -25...115 0mV 1
50 potentiometer 0...160 Ohm 1
51 potentiometer 0...450 Ohm 1
52 potentiometer 0...1600 Ohm 1
53 potentiometer 0...4500 Ohm 1
S.Lin Linearization
(only at S.tYP = 23,24,30,41 and 42 adjustable)
0
0 none
1 Linearization to specification. Creation of linearization table
with 8800/8840 Configurator (engineering tool) possible.
The characteristic for KTY 11-6 temperature sensors is
preset.
Corr
Measured value correction / scaling
(only at S.tYP = 23,24,30,41 and 42 adjustable)
0
0 Without scaling
1 Offset correction (at CAL level)
2 2-point correction (at CAL level)
3 Scaling (at PArA level)
In.F -1999...9999 Alternative value for error at INP3 OFF
fAI3 Forcing INP3 (only visible with 8800/8840 Configurator!) 0
0 No forcing
1 Forcing via serial interface