Thermo Fisher Scientific CyberComm 6000 for CyberScan Series 6000 - Manual (Page 49)

Instruction Manual CyberComm 6000
43
4.2.5 Taking a Snap Shot of Graph
In single-channel measurement mode, you can choose to view variations of the
measurement in a graphical manner by clicking on Show Graph button (Figure 36).
The graph plots the variations of the measured parameter continuously. You can take
a ‘snap shot’ of the graph any time and save it for further analysis. These saved snap
graphs can be viewed in Reports control tab.
To take a snap shot:
1. Select channel & parameter, from the Measure control tab.
2. Click on Measure tab in the workspace.
3. Click Show Graph button. The graph starts plotting the variations of the
measured parameter.
4. When you wish to take snap shot of the graph, click Snap Graph button.
CyberComm saves the snap shot with a time stamp and then it shows you a
confirmation message.
5. To view saved snap shots, click Reports control tab and then click View Graph.
Figure 36 : Taking Snap shot of graph