Thermo Fisher Scientific CyberComm 6000 for CyberScan Series 6000 - Manual (Page 42)

Instruction Manual CyberComm 6000
36
3.9 Temperature Standardization
CyberComm allows you to specify standardization temperature if you wish to perform
standardization at a specific temperature other than the temperature reading shown
by the meter.
To specify standardization temperature:
1. Make sure Multi-channel check box is not selected in the Measure control tab.
2. Select the channel and its parameter
3. Click on Standardization tab in the workspace.
4. Electrode Configuration Dialog appears.
5. Click Temperature Standardization button. A dialog box appears. (Figure 31)
6. Enter the temperature that you wish to perform standardization for the selected
channel/parameter.
7. Click OK to confirm. You can proceed with standardizing the selected
channel/parameter.
Figure 31 : Standardization Temperature
Note: You can reset the standardization temperature back to the actual
reading of the meter. Click Standardization Temperature button and
then click Reset.