Thermo Fisher Scientific CyberComm 6000 for CyberScan Series 6000 - Manual (Page 38)

Instruction Manual CyberComm 6000
32
3.5 Add a new electrode to the project
You need to add electrode serial number into CyberComm before you can perform a
standardization using that electrode. The serial number uniquely identifies the
electrode. CyberComm does not allow duplicating electrode serial number.
To add a new electrode:
1. Make sure Multi-channel check box is not selected in the Measure control tab.
2. Select the channel and its parameter.
3. Click on Standardization tab in the workspace.
4. Electrode Configuration Dialog appears.
5. Click Add new electrode button. A dialog box appears (Figure 28)
6. Enter serial number of the new electrode. Click OK.
7. The newly added electrode serial number appears in the Electrode Serial No list.
Standardization data is empty for this electrode as no standardization is done yet.
You may select this electrode and perform standardization at any time.
Figure 28 : Adding a new electrode