beautypg.com

P4.2: stop bit – Thermo Fisher Scientific CyberScan CON 10/CON 100/CON 200 User Manual

Page 40

background image

37

8.5.3

P4.2: Stop Bit

The Stop Bit allows the selection of the proper stop bit when transmitting to other peripheral

devices (such as printers). You can select the stop bit to be 1 or 2 depending upon the model

and make of the peripheral device (the instruction manual of the peripheral device should

indicate the number of stop bits used). Under default conditions, the stop bit is 2.

At this point, if the ENTER/RANGE key is pressed, the unit reverts to its measurement mode.

Figure 35: The Stop Bit option