Thermo Fisher Scientific CyberScan CON 10/CON 100/CON 200 - Manual (Page 30)

27
8 S E T T I N G U P T H E C Y B E R S C A N ( F O R C Y B E R S C A N
CON 100/200 ONLY )
8.1 SETUP program
In the SETUP mode in CyberScan CON 100/200 meter, there are four main programs. Each
has been divided into several options. The programs and options are elaborated under the
following sections:
PROGRAM DESCRIPITION SECTION
1 Common functions 8.2
2 Instruments setup 8.3
3 TDS units and factor 8.4
4
Communication
parameters
8.5
To enter the SETUP mode, press the SET key from either the
µ
S or ppm measurement MEAS
mode. The meter automatically enters Program 1, Option 0 (P1.0). The meter prompts you
with the program numbers in the secondary field of the display.
NOTE: Entry to SETUP is only accessible from the MEAS mode.
Selection of the ENTER/RANGE key confirms selection of the options chosen. The instrument
then automatically scrolls to the next program. Within each program, you can use MI/ ! or
MR/ " key to make appropriate selections. There are some options that permit the viewing of
data and are useful for diagnostic purposes.
Ensure that the ENTER/RANGE key is pressed to confirm your option in each program.
To exit from the program after the confirmation of choice or to abort from the SETUP mode,
press the CAL/MEAS key to return to the MEAS mode.
To exit SETUP
NOTE: You may press the CAL/MEAS key to exit SETUP mode at any time.