Thermo Fisher Scientific CyberScan CON 10/CON 100/CON 200 - Manual (Page 12)

9
3.5 Connecting the RS 232C cable (only for CyberScan CON 200)
The CyberScan Conductivity CON 200 meter provides an RS 232C output for you to transmit
the reading either to a printer or a computer. This is extremely useful in instances where the
meter is used for continuous monitoring of a certain process or experiment. The data output to
the printer or computer can be then evaluated.
The data is output in the ASCII format. This format allows the data to be imported by a wide
variety of software that read ASCII data (e.g. LOTUS 123 C, Microsoft Excel, etc.).
Eutech Instruments also provides software that can capture the data transmitted into an ASCII
file for later use.
a) Open the communication port cover located at the bottom of the meter as shown in
Figure 10. Do not use excessive force when doing this.
b) Noting the orientation of the RS 232C connector, plug the RS 232C male connector into
the RS 232C port of the meter.
c) Fasten the connector by fastening the two screws at the side of the male connector.
Figure 9: Inserting the A.C. power adapter