Thermo Fisher Scientific CyberScan CON 10/CON 100/CON 200 - Manual (Page 28)

25
7.2 Printing errors
The meter displays an error by blinking the printer
and error annunciators if the printer is not ready to
receive data or if the printer is off. As soon as the
printer is ready, the error display will automatically go
off. While the meter is displaying the printer error, the
user may press the CAL/MEAS key to go back to the
measurement mode.
7.3 Sending data to the computer
To send data to the computer, connect the RS 232C
cable from the base of the meter to the COMM port 1
of the computer. Load and run the CYDATA data
acquisition program ensuring that the parameters of
the settings in the meter and the CYDATA are
identical.
To send data to the computer, press the key.
7.4 Printing measurement data
To print any data that is currently being measured, press the key. Note that the printing
capability is available for the COND, TDS and TEMP modes.
The data will be printed onto the printer paper or the screen of the CYDATA program
automatically as illustrated in Page 26.
7.5 Printing data from memory
The CyberScan CON 200 meter can print data that is stored in the memory. Firstly, ensure
that the cables are properly connected to either the printer or the computer and the units are
configured to receive the data from the meter.
Change the mode to the mode of measurement from
which data needs to be printed.
Scroll to the data that needs to be printed by pressing
the MR/ " key. To print, press the key. The data
displayed will then be sent to the printer or the computer.
An example of the printout is shown in Page 26.
Figure 20: Display of printing
error
Figure 21: Sending data to the
computer
Figure 22: Printing data from
memory