Spectrex 40/40R - Single IR Flame Detector - Manual (Page 36)

SharpEye TM Single IR Flame Detector User Guide
24 Installing the Tilt Mount (part no. 40/40-001)
Figure 5 shows the Tilt Mount Assembly with dimension in both millimeters
and inches.
Figure 5: Tilt Mount Assembly (dimensions in mm and inches)
To install the Tilt Mount and Detector:
1 Place the tilt mount in its designated location and secure it with four (4)
fasteners through four (4) holes 7 mm in diameter. Use the four (4)
screws and spring washers according to the kit (see Table 13 and
Table 14).
Note: Removing the detector for maintenance purpose does not require
the Tilt Mount to be removed).
2 Unpack the detector.
3 Place the detector with its conduit/cable entries pointing downwards on
the holding plate of the tilt mount. Secure the detector with 5 /
16
" 18 UNC
x 1" screw to the tilt mount.
4 Release the Horizontal and Vertical Locking Screws using 3 /
16
" Hex Key
such that the detector can be rotated. Point the detector towards the
protected area and make certain that the view of the area is
unobstructed. Secure the detector in that position by tightening the
locking screws on the tilt mount. (Make sure the detector is in the
correct position.)
The detector is now correctly located, aligned and ready to be connected
to the system.