SHIMPO DT-365E - Manual (Page 13)

13
4.3.2.2 Changing the emission count (frequency) to double or half
The emission count (frequency) can be changed to double or half of the current setting value using
the key operation on internal oscillation emission.
1) To change the emission count (frequency) to double of the current setting value
Each press of the "x2" key changes the emission count (frequency) to double of the current
setting value on internal oscillation emission.
Operation Display
×2
Each press
increases the
emission count to
double
INT EXT
FPM
DUR
PHA
INT EXT
FPM
DUR
PHA
INT EXT
FPM
DUR
PHA
Emission count 1,500fpm
Emission count 3,000fpm Emission count 6,000fpm
Ч2
Ч2
* If the doubled emission count (frequency) goes beyond the value in the measurement range, the
key operation will be disabled. The emission count (frequency) after change provides the value
according to the setting display resolution (for details about the setting display resolution, refer to
"5 Specifications"). For this reason, after pressing the "x2" key and doubling the emission count
(frequency), the value may not be returned to the initial value even by pressing the "÷2" key and halving
it.
2) To change the emission count (frequency) to half of the current setting value
Each press of the "÷2" key changes the emission count (frequency) to half of the current setting
value on internal oscillation emission.
Operation Display
÷2
Each press
decreases the
emission count to
half
INT EXT
FPM
DUR
PHA
INT EXT
FPM
DUR
PHA
INT EXT
FPM
DUR
PHA
Emission count 1,500fpm
ч2
ч2
Emission count 750fpm Emission count 375fpm
* If the half of the emission count (frequency) goes below the value in the measurement range, the
key operation will be disabled. The emission count (frequency) after change provides the value
according to the setting display resolution (for details about the setting display resolution, refer to
"5 Specifications"). For this reason, after pressing the "÷2" key and halving the emission count
(frequency), the value may not be returned to the initial value even by pressing the "x2" key and
doubling it.