SHIMPO DT-365E - Manual (Page 10)

10
4 Functions and operations
4.1 Power ON/OFF
Press the power switch when the power is OFF to turn the power ON.
When the power is turned ON, the model is indicated, followed by internal oscillation emission or
external synchronous emission.
Operation Display
When the power is
OFF
Press the power
switch
When the power is previously turned OFF
Internal oscillation emission
When the power is previously turned OFF
External synchronous emission
INT EXT
FPM
DUR
PHA
INT EXT
FPM
DUR
PHA
The screen of internal oscillation emission
is indicated, and emission starts.
The screen of external synchronous emission
is indicated, and the unit enters the standby
mode for the external signal.
INT EXT
FPM
DUR
PHA
* The indication may go off immediately after the power is turned ON. In that case, charge the unit because
the remaining battery level becomes low. For details about charging, refer to "2.3 Charging".
Press the power switch when the power is ON to turn the power OFF, then the indication goes off.
Operation Display
When the power is ON
Press the power
switch
INT EXT
FPM
DUR
PHA
Indicated letters go off.
INT EXT
FPM
DUR
PHA
* When the power is turned ON, the following indication may be displayed.
The following indication is an error message when reading the previously used setting value fails. Press
the "x2" key to reset the previously used setting value, and return to the normal emission screen from the
error message display.
Operation Display
×2
Press the x2 key
INT EXT
FPM
DUR
PHA
Returns to the normal setting screen
×2
INT EXT
FPM
DUR
PHA
Error display
Failure to read the previously used setting value